Assembly Swivel Bar Stools
Swivel bar stools – Place the seat frame on the floor with swivel plate down. Release the bolts in the upper end of a stool legs in holes in the frame. Twist the nuts on both bolts as far as possible by hand. Tighten the nuts firmly. Attach three other legs to the seat frame in the same way.
2nd Add round or rounded corners square separator between the four legs, and line up the holes in the separator with the holes of the legs. Slide bolts through the holes in the separator and into the legs. Tighten the screws with a Phillips screwdriver. 3rd Place seat swivel bar stools up and down on the floor. Remove the seat screws from the bottom of the seat .Rotate the rotatable plate on the seat frame to a position that leaves all four holes are visible from below.
Put the frame of the seat bottom and line up the holes in the rotating plate with holes in the seat. Slip a lock washer, then a flat washer on each of the screws and place one at each hole in the bottom of the swivel plate and the holes in the seat. Tighten the four screws with a Phillips screwdriver or Allen wrench. 4th Turn feces, or stool upright and spin seat to test the swivel action. Your swivel bar stools was assemblied.swivel chair assembly, swivel plates for bar stools